Highland wear can be a tricky business! Especially for men wearing a kilt for the first time. It’s a whole new experience and we want to make sure you get everything just right so your outfit looks perfect! Houston Kiltmakers want to assist you any way we can so have a look below at our useful hints and tips on highland wear!
1. Put your socks on first; make sure ribs on socks are running vertical and not twisted. Top of socks should be parallel and same length. Put the garter flashes on socks to the outside of your leg, making sure there is a three to four inch gap between the top of the socks and bottom of the kilt. About one inch below the knee is an ideal resting point for your socks.
2. Put your sgian dubh down the right leg of your sock. If you are left handed it can be worn down your left leg.
3. Put your ghillie brogue shoes on, twist the laces three to four times and take round back of the calf. Return them to the front of your shin about 2/3 of the way up and tie in a normal bow quite firmly and show to the front or side as preferred. If you find the laces are constantly slipping down and becoming loose then wrap them lower down your leg or round your ankle a couple of times.
4. Put on your shirt making sure any creases are ironed out, and put your cufflinks on.
5. Make sure the kilt pin is on the front apron only, on the fringed side of your kilt about two inches from the bottom and side of the fringe.
6. Put your kilt on making sure it is a good fit and it sits well up (about one and a half inches above the hip bone). Then look at the front apron and make sure the centre line is down the middle of the kilt so it is well balanced with pleats to the back. When looking in the mirror the kilt should be in an A shape with the sides well balanced.
7. Clip the chain strap onto the sporran, then put the chain strap through the kilt belt loops and fasten your sporran at the back of the kilt. Make sure the sporran is centred to front apron, positioned about four to five inches below the top of the kilt. You can rest the chain strap on top of the kilt buckles if you wish. This will secure the sporran a bit better.
8. Then put the belt and buckle on covering the chain strap. We recommend jacket wearing a belt as if you remove your jacket and waistcoat during an event the outfit will look bare, so we include a belt with all our hires. Check that the belt buckle is about one to two inches above the sporran.
9. If you are wearing a shoulder plaid, fasten under your left hand jacket lapel and fasten with plaid brooch onto jacket only.
10. Put on your waistcoat, then jacket. Make sure the jacket is fitting square on, with the waistcoat buttons, tie, sporran, buckle and kilt centre line all straight up and down. If driving to a venue, we advise that you hang the jacket up in the back and put it on when you get out the car. Try not to drive with your jacket on as it may crease.
11. Finally put on your tie, bow, ruche or standard tie.
12. Make sure you have a dram in your sporran flask and have an optional sprig of heather for your button hole.
We hope this information helps! Please comment below with any questions!
Houston Traditional Kiltmakers Est. 1909
Comments